Angle per side = arctan((D - d) / (2 x L)). A taper from 1.000 to 0.800 inch over 2 inches has a 2.862 degree angle per side (5.725 degree included) and 1.2 inches of taper per foot. Set the compound to the angle per side.
The compound is set to the angle per side, never the included angle. Tailstock offset only works for tapers between centers and is best kept to shallow tapers.
Tools that match your numbers
Sine bars to check the taper angle
Listed 5 inch sine bars. The stack height is computed from your taper angle.
Nothing we carry is listed for that number. Change a value above, or compare the wider range below.
- Smaller option, below your numberSPI 13-186-2 Sine Bar: 5 inch Center-to-CenterUnder $100
For a 2.862 degree taper a 5 in sine bar needs a 0.2497 in gauge block stack (bar length x sine of the angle), which you can check the taper against.
Check price on Amazon - Smaller option, below your numberFowler 52-455-035-0Under $100
For a 2.862 degree taper a 5 in sine bar needs a 0.2497 in gauge block stack (bar length x sine of the angle), which you can check the taper against.
Check price on Amazon
Gauge blocks to build that stack
Matched on the range each listing gives against the stack height your angle needs.
Nothing we carry is listed for that number. Change a value above, or compare the wider range below.
- Smaller option, below your numberHFS 81 PC Gauge Block Set Economy Grade Calibration NIST-TraceableUnder $250
Your stack height is 0.2497 in, inside the listed range (81 blocks, 0.050 to 4 in).
Check price on Amazon - Smaller option, below your numberBENCH WIZARD 36 Piece Steel Gauge Block SetUnder $100
Your stack height is 0.2497 in, inside the listed range (36 blocks, 0.1 to 4.0 in).
Check price on Amazon
Eye protection to go with it
Glasses whose listing states ANSI Z87.1. Check the markings on the lens and frame and follow the maker's instructions; this is not a safety guarantee.
Nothing we carry is listed for that number. Change a value above, or compare the wider range below.
- Smaller option, below your numberTICONN 1PK Anti-Fog Safety Glasses for Men & WomenUnder $25
Eye protection for the machine that runs these numbers. The listing states ANSI Z87.1; check the markings on the lens and frame and follow the maker's instructions.
Check price on Amazon - Smaller option, below your numberErgodyne Skullerz SIXTEN Safety Glasses with Side ShieldsUnder $25
Eye protection for the machine that runs these numbers. The listing states ANSI Z87.1; check the markings on the lens and frame and follow the maker's instructions.
Check price on Amazon
Tools for this job
The tooling this calculation is usually for, spread across the price range.
How does the taper calculator work?
Tapers are described three ways that mean the same thing: diameters over a length, taper per foot, and angle. Lathe compounds are graduated in degrees per side, so the angle per side is the number to set. Check the result with bluing on a mating part or with a dial indicator along the length.
Frequently asked questions
Should I set the compound to the included angle?
No. The compound swivels the tool path relative to the spindle axis, so it must be set to half the included angle, the angle per side. Setting the included angle doubles the taper, which is the single most common taper mistake.
Keep going
Formulas are standard shop math; starting speeds are conservative conventions for hobby machines. Not professional engineering advice. Wear eye protection and keep hands, gloves and sleeves clear of rotating work.