- Matching drill setDrill America - DWD29J-CO-PC 29 Piece M35 Cobalt Drill Bit Set in...Under $250
Matched to this page: a drill set for Gray cast iron (class 30). The listing says cobalt (M35), which is what the maker offers for tougher metals; it lists fractional sizes 1/16 to 1/2 in, which covers every drill row in the table up to 1/2 inch.
Check price on Amazon
Drill Gray cast iron (class 30) with HSS at about 60 SFM: 458 RPM for a 1/2 inch drill, 916 RPM for 1/4 inch, feeding about 0.0037 in/rev at 1/4 inch.
What RPM and feed for Gray cast iron (class 30)?
| Drill | RPM | Feed (in/rev) | Feed (IPM, capped 2500 RPM) | Matching product |
|---|---|---|---|---|
| 0.0625" | 3,667 | 0.0009 | 2.34 | |
| 0.125" | 1,833 | 0.0019 | 3.44 | |
| 0.1875" | 1,222 | 0.0028 | 3.44 | |
| 0.25" | 917 | 0.0037 | 3.44 | |
| 0.3125" | 733 | 0.0047 | 3.44 | |
| 0.375" | 611 | 0.0056 | 3.44 | |
| 0.5" | 458 | 0.0075 | 3.44 | |
| 0.625" | 367 | 0.0094 | 3.44 | |
| 0.75" | 306 | 0.0112 | 3.44 |
Tools for cutting Gray cast iron (class 30)
How does Gray cast iron (class 30) machine?
Gray cast iron is machined dry. It produces fine abrasive dust rather than chips, so keep it off the lathe ways and wear a dust mask. The outer skin of a casting is hard and sandy: take the first cut under it.
Why a HSS twist drill?
Twist drill speeds are set lower than turning speeds because the cutting edge is buried in the hole with no escape for heat. Peck deep holes (clear chips every one to two diameters), and use cutting oil in everything except cast iron, brass and plastics.
Adjust speeds with the RPM calculator and milling feeds with the feed rate calculator. The cutting speed chart compares every material.
Frequently asked questions
What SFM for Gray cast iron (class 30)?
A starting surface speed of 70 SFM with HSS and 250 SFM with carbide, and 60 SFM for HSS drills. These are conservative for hobby machines; raise them in steps if the chips come off clean and the tool stays cool. Gray cast iron (class 30) rates good for machinability.
What happens if my machine cannot reach the RPM?
Run at your top speed. Running below the ideal surface speed only makes the job slower; it does not damage the tool. For milling and drilling, keep the chip load per tooth or feed per revolution the same so the edge keeps cutting instead of rubbing, which lowers the feed in inches per minute in proportion.
Other tools in Gray cast iron (class 30)
Other materials with a HSS drill
- 6061-T6 aluminum
- 7075-T6 aluminum
- 360 free-machining brass
- 932 bearing bronze
- 110 copper
- 12L14 leaded steel
- 1018 cold rolled steel
- 1045 medium carbon steel
- All