2" x 2" x 0.12" wall carbon steel square tube weighs 3.071 lb per ft (4.57 kg per m). Weight = cross-section area x length x 0.2836 lb per cubic inch.
Cut and measure your stock
- Metal bandsawDEWALT - GID-298457 Portable Band SawUnder $500Check price on Amazon
- Bandsaw bladeAYAO 64-1/2 inch X 1/2" X 14TPI Bimetal M42 Bandsaw Blades for Metal...Under $25Check price on Amazon
- CaliperiGAGING 6-Inch 150 mm Dial CaliperUnder $50Check price on Amazon
How much does carbon steel square tube weigh per foot?
| Size | Area (sq in) | lb per ft | kg per m | 12 ft length, lb |
|---|---|---|---|---|
| 0.75" x 0.75" x 0.065" wall | 0.1781 | 0.606 | 0.90 | 7.3 |
| 1" x 1" x 0.065" wall | 0.2431 | 0.827 | 1.23 | 9.9 |
| 1" x 1" x 0.12" wall | 0.4224 | 1.438 | 2.14 | 17.3 |
| 1.5" x 1.5" x 0.12" wall | 0.6624 | 2.254 | 3.35 | 27.1 |
| 2" x 2" x 0.12" wall | 0.9024 | 3.071 | 4.57 | 36.9 |
| 2" x 2" x 0.25" wall | 1.7500 | 5.956 | 8.86 | 71.5 |
| 3" x 3" x 0.1875" wall | 2.1094 | 7.179 | 10.68 | 86.1 |
| 4" x 4" x 0.25" wall | 3.7500 | 12.762 | 18.99 | 153.1 |
Formula: area = outside squared minus (outside minus 2 x wall) squared; weight = area x length x 0.2836 lb/in3. Corner radii are ignored, so real stock runs one to three percent lighter than the table. For any other size use the metal weight calculator.
Cut and measure your stock
Frequently asked questions
How do you calculate the weight of carbon steel square tube?
Multiply the cross-section area in square inches by the length in inches and by the density, 0.2836 lb per cubic inch for carbon steel (1018 / A36). For this shape the area is: area = outside squared minus (outside minus 2 x wall) squared. A foot of stock is 12 inches, so weight per foot is area x 12 x 0.2836.
How does carbon steel compare with steel by weight?
Carbon steel is the baseline at 0.2836 lb per cubic inch. Stainless is about 2% heavier, brass about 8% heavier, copper about 14% heavier, and aluminum about 66% lighter for the same size.
Other carbon steel shapes
Square tube in other metals
Keep going
Weights from typical published densities; actual alloys and mill tolerances vary by a few percent. Not an engineering load calculation.